Skip to content

Earlier editions: 20222019

Chapter 12 — HYDRONICS

1211.2 Pipe Bends — 2025 California Mechanical Code

California Mechanical Code (Title 24, Part 4) · 2025 edition · updated 2026-10-23 · California

CBSC: official editions, supplements and errata

Italicized text is a California amendment to the model code, as printed in the official publication.

Cite as: 2025 California Mechanical Code (Title 24, Part 4) § 1211.2 · Effective January 1, 2026 · Official source: Building Standards Commission

Pipe bends shall be formed in accordance with Section 1211.2.1 for PEX or Section 1211.2.2 for

PE.

1211.2.1 Crosslinked Polyethylene (PEX) Tubing. Cross-linked polyethylene (PEX) tubing bends shall have a bend radius of not less than eight times the outside diameter of the tubing or shall be in accordance with the manufacturer’s installation instructions.

1211.2.2 Polyethylene (PE) Plastic Pipe/Tubing. Polyethylene pipe and tubing bends shall have a bend radius in accordance with Table 1211.2.2. When a fitting or flange connection is present in the pipe bend, the minimum bend radius shall be one hundred times the pipe outside diameter (OD) for a distance of five times the pipe diameter on either side of the fitting location.

»

»

TABLE 1211.2.2

MINIMUM BEND RADIUS FOR PE PIPE

INSTALLED IN OPEN CUT TRENCH

1211.2.3 Polyethylene of Raised Temperature (PE- RT) Tubing. Polyethylene of raised temperature (PE-RT) tubing bends shall have a bend radius of not less than eight times the outside diameter of the tubing or shall be in accordance with the manufacturer’s installation instruc tions.

Get a plain-English answer with a citation back to this text.

Ask AI about this code
▸Contents — California Mechanical Code (Title 24, Part 4)

GoCodebook provides public access, search, citation, multilingual explanation, and practical interpretation of legally adopted building regulations. It is not a substitute for the official ICC or California code publications.