1211.9 Polyethylene/Aluminum/Polyethylene (PE-AL-

PE). Joints between polyethylene/aluminum/ polyethylene (PE-AL-PE) pipe or fittings shall be installed in accordance with one of the following methods: (1) Mechanical joints for PE-AL-PE pipe, tubing, or fittings

shall be either of the metal insert fittings with a split ring

(1) Mechanical joints for PE-AL-PE pipe, tubing, or fittings

shall be either of the metal insert fittings with a split ring and compression nut or metal insert fittings with copper crimp rings. Metal insert fittings shall comply with ASTM F1974. Crimp insert fittings shall be joined to the pipe by placing the copper crimp ring around the outer circumference of the pipe, forcing the pipe material into the space formed by the ribs on the fitting until the pipe contacts the shoulder of the fitting. The crimp ring shall then be positioned on the pipe so the edge of the crimp ring is 1 / 8 of an inch (3.2 mm) to 1 / 4 of an inch (6.4 mm) from the end of the pipe. The jaws of the crimping tool shall be centered over the crimp ring and tool perpendicular to the barb. The jaws shall be closed around the crimp ring and shall not be crimped more than once. (2) Compression joints for PE-AL-PE pipe, tubing, or fittings

shall be joined through the compression of a split ring, by

(1) Butt-fusion joints shall be installed in accordance with

ASTM F2620 and shall be made by heating the squared ends of two pipes, pipe and fitting, or two fittings by holding ends against a heated element. The heated element shall be removed where the proper melt is obtained, and joined ends shall be placed together with applied force. (2) Electro-fusion joints shall be heated internally by a con ductor at the interface of the joint. Align and restrain fit

Electro-fusion joints shall be heated internally by a con ductor at the interface of the joint. Align and restrain fitting to pipe to prevent movement and apply electric

(2) Compression joints for PE-AL-PE pipe, tubing, or fittings

shall be joined through the compression of a split ring, by a compression nut around the circumference of the pipe. The compression nut and split ring shall be placed around the pipe. The ribbed end of the fitting shall be inserted onto the pipe until the pipe contacts the shoulder of the fitting. Position and compress the split ring by tightening the compression nut onto the insert fitting.