9-204.030 - DEVELOPMENT STANDARDS — San Joaquin County Zoning Code

Table 9-204.030 prescribes the development standards for the P-F, M-X, and AP-X Zones. The numbers in each illustration refer to corresponding regulations in the "#" column in the associated table.

TABLE 9-204.030: DEVELOPMENT STANDARDS—P-F, M-X, AND AP-X ZONES

District	P-F	M-X	AP-X	#
Lot and Density Standards
Minimum Lot Size (sq.	None	None	None
ft.)
Minimum Lot Width (ft.)	100	None	100	①
Building Form and Location
Maximum Height (ft.)1	90	605	N/A2	②
Minimum Setbacks (ft.)3
Front	20	None	N/A4	③
Interior Side	None	None	N/A4	④
Street Side	20	None	N/A4	⑤
Rear	None	None	N/A4	⑥

Notes:

See Section 9-400.050 or any applicable Special Purpose Plan, for exceptions to height limits.
The maximum height within the AP-X Zone shall be as specified in the Stockton Metropolitan Airport Special Purpose Plan.
Setbacks for yards shall be measured from the planned ultimate right-of-way width of the roadway, as shown on the General Plan or applicable Specific Plan or Special Purpose Plan.
The setbacks for yards within the AP-X Zone shall be as specified in the Stockton Metropolitan Airport Special Purpose Plan.
Public buildings may be up to 90 feet in height.

(a)

Lot Area and Width. Lots shall have the minimum areas and minimum widths set forth in Table 9-204.030.

(b)

Yard Dimensions. Yards shall have the minimum dimensions set forth in Table 9-204.030, except as modified for the Public Facilities Zone as follows:

(1)

Reduction of Required Yards. Required yards may be reduced as follows:

(A)

If more than 50 percent of the block on which the lot sits is developed, the required yard shall be the average of the existing yard dimensions of permitted structures on the block. In no case, however, shall a street side yard be less than 10 feet in width.

(B)

If the lot is less than 75 feet in width, the street side yard may be reduced to 10 feet in width.

(2)

Increase in Required Yards. If a side or rear yard abuts a lot developed with a conforming residential use, a lot zoned residentially, or a lot shown on the General Plan Map for residential development, such side yard shall be increased to 20 feet in width.

(3)

Development within Required Yards. The following structures may be located in or extend within required yards, subject to the provisions specified:

(A)

Architectural features, subject to the provisions of Chapter 9-400, General Site Regulations;

(B)

Screening, including fences and gates, subject to the provisions of Sections 9-400.040, Fences and Screening, and 9-400.050, Screening of Equipment;

(C)

Additions to nonconforming single-family dwellings, subject to the provisions of Chapter 9-405, Nonconformity Provisions; and

(D)

Structures adjacent to and associated with railroad spurs.

(c)

Height. Buildings and structures within the P-F, M-X, and AP-X Zones shall not exceed the heights set forth in Table 9-204.030, except as permitted by Section 9-400.020, Building Projections into Required Yards. Buildings and structures in these zones shall also be subject to the following limitations on height:

(1)

Within airport imaginary surface zones, buildings and structures shall comply with the height restrictions specified by the FAA or by the Stockton Metropolitan Airport regulatory documents.

(2)

In the Airport Multi-Use Zone, buildings and structures shall comply with the height requirements specified in the Stockton Metropolitan Airport Special Purpose Plan.

(3)

Screening devices, including fences, gates, and gateposts, shall comply with the requirements specified in Chapter 9-402, Landscaping.

Series 300: - Master Plans, Special Purpose Plans, Specific Plans, and Planned Development Chapter 9-300 - Master Plans