704.3 Commercial Sinks.
California Plumbing Code (Title 24, Part 5) · 2019 edition · updated 2026-09-10 · California
Italicized text is a California amendment to the model code, as printed in the official publication.
Pot sinks, scullery sinks, dishwashing sinks, silverware sinks, and other similar fixtures shall be connected directly to the drainage system. A floor drain shall be provided adjacent to the fixture, and the fixture shall be connected on the sewer side of the floor drain trap, provided that no other drainage line is connected between the floor drain waste connection and the fixture drain. The fixture and floor drain shall be trapped and vented in accordance with this code.
Get a plain-English answer with a citation back to this text.
Ask AI about this code▸Contents — California Plumbing Code (Title 24, Part 5)
- Chapter 1 — GENERAL CODE PROVISIONS
- Chapter 2 — DEFINITIONS
- Chapter 3 — GENERAL REGULATIONS
- Chapter 4 — PLUMBING FIXTURES AND FIXTURE FITTINGS
- Chapter 5 — WATER HEATERS
- Chapter 6 — WATER SUPPLY AND DISTRIBUTION
▸Chapter 7 — SANITARY DRAINAGE
Overview- 701.2 Drainage Piping. Materials for drainage piping shall
- 701.4 Continuous Wastes. Continuous wastes and fixture
- 701.5 Lead. (See Table 1701.1) Sheet lead shall comply with
- 701.6 Caulking Ferrules. Caulking ferrules shall be manufactur…
- 701.7 Soldering Bushings. Soldering bushings shall be
- 701.3 Drainage Fittings. Materials for drainage fittings
- 702.0 Fixture Unit Equivalents.702.1 Trap Size. The unit equiv…
- 702.2 Intermittent Flow. Drainage fixture units for intermitte…
- 702.3 Continuous Flow. For a continuous flow into a
- 703.2 Maximum Number of Fixture Units. Table 703.2
- 703.3 Sizing per Appendix C. For alternate method of
- 704.2 Single Vertical Drainage Pipe. Two fixtures set
- 704.3 Commercial Sinks. Pot sinks, scullery sinks, dishwashing…
- 705.1 ABS and ABS Co-Extruded Plastic Pipe andJoints. Joining …
- 705.2 Cast-Iron Pipe and Joints. Joining methods for
- 705.3 Copper or Copper Alloy Pipe (DWV) andJoints. Joining met…
- 705.4 Galvanized Steel Pipe and Joints. Joining methods for ga…
- 705.5 Polyethylene (PE) Sewer Pipe. Polyethylene (PE)
- 705.6 PVC and PVC Co-Extruded Plastic Pipe andJoining Methods.…
- 705.7 Stainless Steel Pipe and Joints. Joining methods for sta…
- 705.8 Vitrified Clay Pipe and Joints. Joining methods
- 705.9 Special Joints. Special joints shall comply with Section…
- 705.10 Joints Between Various Materials. Joints
- 706.2 Horizontal to Vertical. Horizontal drainage lines,
- 706.3 Horizontal to Horizontal. Horizontal drainage lines
- 706.4 Vertical to Horizontal. Vertical drainage lines connecti…
- 707.0 Cleanouts.707.1 Plug. Each cleanout fitting for cast-iro…
- 707.2 Approved. Each cleanout fitting and each cleanout
- 707.3 Watertight and Gastight. Cleanouts shall be
- 707.4 Location. Each horizontal drainage pipe shall be provide…
- 707.5 Cleaning. Each cleanout shall be installed so that it
- 707.6 Extension. Each cleanout extension shall be considered a…
- 707.7 Interceptor. Each cleanout for an interceptor shall be
- 707.8 Access. Each cleanout, unless installed under an
- 707.9 Clearance. Each cleanout in piping 2 inches (50 mm)
- 707.10 Fittings. Cleanout fittings shall be not less in size
- 707.11 Pressure Drainage Systems. Cleanouts shall be
- 707.12 Countersunk Cleanout Plugs. Countersunk
- 707.13 Hubless Blind Plugs. Where a hubless blind plug
- 707.14 Trap Arms. Cleanouts for trap arms shall be installed
- 708.0 Grade of Horizontal Drainage Piping.708.1 General. Horiz…
- 710.0 Drainage of Fixtures Located Below the Next
- 710.2 Sewage Discharge. Drainage piping serving fixtures that …
- 710.3 Sewage Ejector and Pumps. A sewage ejector or
- 710.4 Discharge Line. The discharge line from such ejector, pu…
- 710.5 Size of Building Drains and Sewers. Building
- 710.6 Backwater Valves. Backwater valves, gate valves,
- 710.7 Drainage and Venting Systems. The drainage and
- 710.8 Sump and Receiving Tank Construction. Sumps
- 710.9 Alarm. Such sumps and receiving tanks shall be automatic…
- 710.10 Sump and Receiving Tank Covers and Vents.
- 710.11 Air Tanks. Air tanks shall be so proportioned as to be
- 710.12 Grinder Pump Ejector. Grinder pumps shall be
- 710.13 Macerating Toilet Systems and PumpedWaste Systems. Fixt…
- 712.2 Water Test. The water test shall be applied to the
- 712.3 Air Test. The air test shall be made by attaching an
- 713.2 Private Sewage Disposal System. Where no public sewer in…
- 713.3 Public Sewer. Within the limits prescribed by Section 71…
- 713.4 Public Sewer Availability. The public sewer shall be
- 711.0 Suds Relief.711.1 General. Drainage connections shall no…
- 713.5 Permit. No permit shall be issued for the installation,
- 713.6 Lot. On every lot or premises hereafter connected to
- 713.7 Installation. In cities, counties, or both where the
- 714.2 Prohibited Water Discharge. No rain, surface, or
- 714.3 Prohibited Sewer Connection. No cesspool, septic tank, s…
- 714.4 Commercial Food Waste Disposer. The Authority Having Jur…
- 714.5 Tanks. An approved type, watertight sewage or wastewater…
- 715.2 Joining Methods and Materials. Joining methods
- 715.3 Existing Sewers. Replacement of existing building
- 717.2 [AGR] Meat and Poultry Processing Plants. The
- 718.2 Support. Building sewer piping shall be laid on a firm
- 718.3 Protection from Damage. No building sewer or
- 719.2 No Additional Cleanouts. Where a building sewer
- 719.3 Building Sewer Cleanouts. Required building
- 719.4 Cleaning. Each cleanout shall be installed so that it
- 719.5 Access. Cleanouts installed under concrete or asphalt
- 719.6 Manholes. Approved manholes shall be permitted to
- 720.0 Sewer and Water Pipes.720.1 General. Building sewers or …
- 721.0 Location.721.1 Building Sewer. Except as provided in Sec…
- 721.2 Abutting Lot. Nothing contained in this code shall be
- 724.2 Toilet soil lines shall be separated from house drainage
- 726.2 Toilet soil lines shall be separated from house drainage
- 727.0 [OSHPD 1] Emergency Sanitary Drainage.727.1 For new acut…
- 722.2 Cesspools, Septic Tanks, and Seepage Pits. A
- 722.3 Filling. The top cover or arch over the cesspool, septic…
- 722.4 Ownership. No person owning or controlling a
- 722.5 Disposal Facilities. Where disposal facilities are
- Chapter 8 — INDIRECT WASTES
- Chapter 9 — VENTS
- Chapter 10 — TRAPS AND INTERCEPTORS
- Chapter 11 — STORM DRAINAGE
- Chapter 12 — FUEL GAS PIPING
- Chapter 13 — HEALTH CARE FACILITIES AND MEDICAL GAS AND MEDICA…
- Chapter 14 — FIRESTOP PROTECTION
- Chapter 15 — ALTERNATE WATER SOURCES FOR NONPOTABLE APPLICATIONS
- Chapter 16 — NONPOTABLE RAINWATER CATCHMENT SYSTEMS
- Chapter 17 — REFERENCED STANDARDS
- Appendix A — RECOMMENDED RULES FOR SIZING THE WATER SUPPLY SYS…
- Appendix B — EXPLANATORY NOTES ON COMBINATION WASTE AND VENT S…
- Appendix C — ALTERNATE PLUMBING SYSTEMS
- Appendix D — SIZING STORM WATER DRAINAGE SYSTEMS
- Appendix E — MANUFACTURED/MOBILE HOME PARKS AND RECREATIONAL V…
- Appendix F — FIREFIGHTER BREATHING AIR REPLENISHMENT SYSTEMS
- Appendix G — SIZING OF VENTING SYSTEMS
- Appendix H — PRIVATE SEWAGE DISPOSAL SYSTEMS
- Appendix I — INSTALLATION STANDARD FOR PEX TUBING SYSTEMS FOR …
- Appendix J — COMBINATION OF INDOOR AND OUTDOOR COMBUSTION AND …
- Appendix K — POTABLE RAINWATER CATCHMENT SYSTEMS
- Appendix L — SUSTAINABLE PRACTICES
- Appendix M — PEAK WATER DEMAND CALCULATOR