Chapter 9 — VENTS
California Plumbing Code (Title 24, Part 5) · 2022 edition · updated 2026-09-10 · California
Italicized text is a California amendment to the model code, as printed in the official publication.
Sections in this part
- 901.1 Applicability. This chapter shall govern the materials,
- 901.2 Vents Required. Each plumbing fixture trap, except
- 901.3 Trap Seal Protection. The vent system shall be
- 902.1 Interceptor. Vent piping shall be permitted to be
- 902.2 Bars, Soda Fountains, and Counter.
- 903.1 Applicable Standards. Vent pipe and fittings shall
- 903.2 Use of Copper or Copper Alloy Tubing. Copper
- 903.3 Changes in Direction. Changes in the direction of
- 904.1 Size. The size of vent piping shall be determined from
- 904.2 Length.
- 905.1 Grade. Vent and branch vent pipes shall be free from
- 905.2 Horizontal Drainage Pipe. Where vents connect to
- 905.3 Vent Pipe Rise.
- 905.4 Roof Termination.
- 905.5 Location of Opening. The vent pipe opening from
- 905.6 Common Vertical Pipe.
- 906.1 Roof Termination. Each vent pipe or stack shall
- 906.2 Clearance. Each vent shall terminate not less than
- 906.3 Use of Roof. Vent pipes shall be extended separately
- 906.4 Outdoor Installations. Vent pipes for outdoor
- 906.5 Joints. Joints at the roof around vent pipes shall be
- 906.6 Lead. (See Chapter 17) Sheet lead shall comply with
- 906.7 Frost or Snow Closure.
- 907.1 Drainage Stack. Each drainage stack that extends 10
- 907.2 Yoke Vent. The yoke vent connection to the vent stack
- 908.1 Vertical Wet Venting.
- 908.2 Horizontal Wet Venting for a Bathroom Group.
- 909.1 General. Traps for island sinks and similar equipment
- 910.1 Where Permitted.
- 910.2 Approval.
- 910.3 Vents. Each combination waste and vent system, as
- 910.4 Size. Each waste pipe and each trap in such a system
- 910.5 Vertical Waste Pipe. No vertical waste pipe shall be
- 910.6 Cleanouts. An accessible cleanout shall be installed
- 910.7 Fixtures. No water closet or urinal shall be installed
- 911.1 Circuit Vent Permitted.
- 912.1 General. The design and sizing of a vent system shall
- 912.2 Minimum Requirements.
- 911.2 Circuit Vent Size and Connection. The circuit vent
- 911.3 Relief Vent.
- 911.4 Slope and Size of Horizontal Branch. The vented
- 911.5 Additional Fixtures.
(Matrix Adoption Tables are non-regulatory, intended only as an aid to the code user. See Chapter 1 for state agency authority and building applications.)
| Adopting Agency | BSC | BSC- CG |
SFM | HCD | DSA | OSHPD | BSCC | DPH | AGR | DWR | CEC | CA | SL | SLC | |||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Adopting Agency | **BSC ** | BSC- CG |
SFM | 1 | 2 | 1-AC | **AC ** | SS | SS/CC | 1 | 1R | 2 | 3 | 4 | 5 | 5 | 5 | 5 | 5 | 5 | 5 | 5 | 5 |
| Adopt Entire Chapter | X | X | |||||||||||||||||||||
| Adopt Entire Chapter as amended (amended sections listed below) |
**X ** | X | X | X | X | **X ** | **X ** | **X ** | X | ||||||||||||||
| Adopt only those sections that are listed below |
|||||||||||||||||||||||
| Chapter/Section | |||||||||||||||||||||||
| 903.1(2) | X | X | X | ||||||||||||||||||||
| 903.1.1 | **X ** | X | |||||||||||||||||||||
| 903.1.2 | X | ||||||||||||||||||||||
| 903.1.3 | X | **X ** | **X ** | **X ** | X | ||||||||||||||||||
| 906.2.1 | **X ** | **X ** | **X ** | **X ** | **X ** | X |
This state agency does not adopt sections identified with the following symbol: The Office of the State Fire Marshal’s adoption of this chapter or individual sections is applicable to structures regulated by other state agencies pursuant to Section 1.11.0.
2022 CALIFORNIA PLUMBING CODE 185
186 2022 CALIFORNIA PLUMBING CODE
CHAPTER 9
VENTS
901.0 General.¶
902.0 Vents Not Required.¶
903.0 Materials.¶
904.0 Size of Vents.¶
905.0 Vent Pipe Grades and Connections.¶
906.0 Vent Termination.¶
907.0 Vent Stacks and Relief Vents.¶
908.0 Wet Venting.¶
909.0 Special Venting for Island Fixtures.¶
910.0 Combination Waste and Vent Systems.¶
911.0 Circuit Venting.¶
912.0 Engineered Vent System.¶
Get a plain-English answer with a citation back to this text.
Ask AI about this code▸Contents — California Plumbing Code (Title 24, Part 5)
- Chapter 1 — GENERAL CODE PROVISIONS
- Chapter 2 — DEFINITIONS
- Chapter 3 — GENERAL REGULATIONS
- Chapter 4 — PLUMBING FIXTURES AND FIXTURE FITTINGS
- Chapter 5 — WATER HEATERS
- Chapter 6 — WATER SUPPLY AND DISTRIBUTION
- Chapter 7 — SANITARY DRAINAGE
- Chapter 8 — INDIRECT WASTES
▸Chapter 9 — VENTS
Overview- 901.1 Applicability. This chapter shall govern the materials,
- 901.2 Vents Required. Each plumbing fixture trap, except
- 901.3 Trap Seal Protection. The vent system shall be
- 902.1 Interceptor. Vent piping shall be permitted to be
- 902.2 Bars, Soda Fountains, and Counter. Traps serving sinks t…
- 903.1 Applicable Standards. Vent pipe and fittings shall
- 903.2 Use of Copper or Copper Alloy Tubing. Copper
- 903.3 Changes in Direction. Changes in the direction of
- 904.1 Size. The size of vent piping shall be determined from
- 904.2 Length. Not more than one-third of the total permitted l…
- 905.1 Grade. Vent and branch vent pipes shall be free from
- 905.2 Horizontal Drainage Pipe. Where vents connect to
- 905.3 Vent Pipe Rise. Unless prohibited by structural conditio…
- 905.4 Roof Termination. Vent pipes shall extend undiminished i…
- 905.5 Location of Opening. The vent pipe opening from
- 905.6 Common Vertical Pipe. Two fixtures shall be permitted to…
- 906.1 Roof Termination. Each vent pipe or stack shall
- 906.2 Clearance. Each vent shall terminate not less than
- 906.3 Use of Roof. Vent pipes shall be extended separately
- 906.4 Outdoor Installations. Vent pipes for outdoor
- 906.5 Joints. Joints at the roof around vent pipes shall be
- 906.6 Lead. (See Chapter 17) Sheet lead shall comply with
- 906.7 Frost or Snow Closure. Where frost or snow closure is li…
- 907.1 Drainage Stack. Each drainage stack that extends 10
- 907.2 Yoke Vent. The yoke vent connection to the vent stack
- 908.1 Vertical Wet Venting. Wet venting is limited to vertical…
- 908.2 Horizontal Wet Venting for a Bathroom Group.
- 909.1 General. Traps for island sinks and similar equipment
- 910.1 Where Permitted. Combination waste and vent systems shal…
- 910.2 Approval. Construction documents for each combination wa…
- 910.3 Vents. Each combination waste and vent system, as
- 910.4 Size. Each waste pipe and each trap in such a system
- 910.5 Vertical Waste Pipe. No vertical waste pipe shall be
- 910.6 Cleanouts. An accessible cleanout shall be installed
- 910.7 Fixtures. No water closet or urinal shall be installed
- 911.1 Circuit Vent Permitted. A maximum of eight flooroutlet w…
- 912.1 General. The design and sizing of a vent system shall
- 912.2 Minimum Requirements. An engineered vent system shall pr…
- 911.2 Circuit Vent Size and Connection. The circuit vent
- 911.3 Relief Vent. A 2 inch (50 mm) relief vent shall be provi…
- 911.4 Slope and Size of Horizontal Branch. The vented
- 911.5 Additional Fixtures. Fixtures, other than the circuitven…
- Chapter 10 — TRAPS AND INTERCEPTORS
- Chapter 11 — STORM DRAINAGE
- Chapter 12 — FUEL GAS PIPING
- Chapter 13 — HEALTH CARE FACILITIES AND MEDICAL GAS AND MEDICA…
- Chapter 14 — FIRESTOP PROTECTION
- Chapter 15 — ALTERNATE WATER SOURCES FOR NONPOTABLE APPLICATIONS
- Chapter 16 — NONPOTABLE RAINWATER CATCHMENT SYSTEMS
- Chapter 17 — REFERENCED STANDARDS
- Appendix A — RECOMMENDED RULES FOR SIZING THE WATER SUPPLY SYS…
- Appendix B — EXPLANATORY NOTES ON COMBINATION WASTE AND VENT S…
- Appendix C — ALTERNATE PLUMBING SYSTEMS
- Appendix D — SIZING STORM WATER DRAINAGE SYSTEMS
- Appendix E — MANUFACTURED/MOBILE HOME PARKS AND RECREATIONAL V…
- Appendix F — FIREFIGHTER BREATHING AIR REPLENISHMENT SYSTEMS
- Appendix G — SIZING OF VENTING SYSTEMS
- Appendix H — PRIVATE SEWAGE DISPOSAL SYSTEMS
- Appendix I — INSTALLATION STANDARDS
- Appendix J — COMBINATION OF INDOOR AND OUTDOOR COMBUSTION AND …
- Appendix K — POTABLE RAINWATER CATCHMENT SYSTEMS
- Appendix L — SUSTAINABLE PRACTICES
- Appendix M — PEAK WATER DEMAND CALCULATOR
- Appendix N — IMPACT OF WATER TEMPERATURE ON THE POTENTIAL FOR …