Chapter 16.40 — LIGHT INDUSTRIAL M-1

This zone district is intended to serve as the light industrial district, permitting light industrial and manufacturing uses which are not objectionable to the neighborhood, and also allow certain types of commercial land uses. Such uses may include manufacture of electronics and consumer goods, food processing, laboratories, machine shops, tire shops, truck terminal and repair stations, storage warehouses, welding shops and fuel yards.

(Ord. 775 (part), 2004).

16.40.020 - General plan consistency.

This zone district is consistent with the industrial land use designation.

(Ord. 775 (part), 2004).

16.40.030 - Density/intensity.

A.

Minimum parcel size: Seven thousand square feet.

B.

Maximum coverage: Seventy-five percent.

(Ord. 775 (part), 2004).

16.40.040 - Site development standards.

A.

Setbacks, minimum:

1.

Front: Twenty feet.

Rear: Ten feet.

Side: Ten feet.

B.

Building:

1.

Maximum height: Forty-five feet unless a conditional use permit is obtained.

C.

Lot Dimensions (minimum)

1.

Width: Seventy (70) feet.

Depth: Seventy five (75) feet.

D.

Parking:

1.

See Parking requirement, Chapter 16.54.

(Ord. 775 (part), 2004).

The following uses are permitted in the M-1 Zone District subject to issuance of a building permit, business license or other required permit(s):

A.

All uses permitted in a C-2 and CH zone without a conditional use permit.

B.

Subject to approval of the Planning Director, light industrial or manufacturing uses which are totally enclosed within a building which are not reasonably objectionable because of noise, smoke, odor, dust, noxious gases, glare, heat, fire hazard, traffic, vibration, storage or handling of explosives or other dangerous material, or other nuisance factors.

C.

Change of existing use on a parcel to a use not reasonably objectionable by the criteria listed in paragraph B.

D.

Emergency shelters.

(Ord. 775 (part), 2004).

(Ord. No. 837, § 1, 5-1-2014)

The following uses and structures are permitted in the M-1 Zone District as an accessory to the primary permitted or conditionally permitted use:

A.

One residential unit to be used solely as a caretaker residence, not exceeding one thousand five hundred (1,500) square feet and otherwise meeting all requirements for a single-family residence.

B.

Fences, walls in compliance with § 16.46.050.

C.

Usual and customary structures associated with the permitted use.

(Ord. 775 (part), 2004).

The following uses are permitted in the M-1 Zone District upon approval and validation of a conditional use permit, in addition to any other permits or licenses required for the use:

A.

All uses in a C-2 or CH zone requiring a conditional use permit, except group care home - large, singleroom occupancy residential unit (SRO), employee housing - small, transitional housing, and supportive housing.

B.

Kennels.

C.

Buildings and structures over forty-five (45) feet in height.

D.

Light industrial and manufacturing uses which do not meet the requirements of § 16.40.050.

(Ord. 775 (part), 2004).

(Ord. No. 837, § 1, 5-1-2014)

Chapter 16.42 - HEAVY INDUSTRIAL M-2

Sections: