Skip to content

Title 17 — ZONING

§ 17.80

Riverside County Zoning Code · 2026-06 edition · updated 2026-07-25 · Riverside County

17.80.020 - Planned commercial development.

Planned commercial developments are permitted provided a land division is approved pursuant to the provisions of Ordinance No. 460.

(Ord. 348, § 9.51)

17.80.030 - Development standards.

The following shall be the standards of development in the C-P-S zones:

A.

There is no minimum lot area requirement, unless specifically required by zone classification for a particular area.

B.

There are no yard requirements for buildings which do not exceed thirty-five (35) feet in height, except as required for specific plans. Any portion of a building which exceeds thirty-five (35) feet in height shall be set back from the front, rear and side lot lines not less than two feet for each foot by which the height exceeds thirty-five (35) feet. The front setback shall be measured from the existing street line unless a specific plan has been adopted in which case it will be measured from the specific plan street line. The rear setback shall be measured from the existing rear lot line or from any recorded alley or easement; if the rear line adjoins a street, the rear setback requirement shall be the same as required for a front setback. Each side setback shall be measured from the side lot line or from an existing adjacent street line unless a specific plan has been adopted in which case it will be measured from the specific plan street line.

C.

No building or structure shall exceed fifty (50) feet in height, unless a greater height is approved pursuant to section 17.172.230. In no event, however, shall a building or structure exceed seventy-five (75) feet in height, unless a variance is approved pursuant to Chapter 17.196.

D.

Automobile storage space shall be provided as required by Chapter 17.188.

E.

All roof mounted mechanical equipment shall be screened from the ground elevation view to a minimum sight distance of one thousand three hundred twenty (1,320) feet.

(Ord. 348.3990 §§ 11, 12, 2001; Ord. 348.3793, 1997; Ord. 348.3584, 1994; Ord. 348.3053, 1989; Ord. 348.2591, 1986; Ord. 348.2000, 1981; Ord. 348.1926, 1981; Ord. 348.1879, 1980; Ord. 348.1702, 1979; Ord. 348.1688, 1979; Ord. 348.1564, 1977; Ord. 348.1481, 1975; Ord. 348.1476, 1975; Ord. 348.1349, 1974; Ord. 348.1340, 1974; Ord. 348.1327, 1974; Ord. 348.517, 1967: Ord. 348 § 9.53)

Chapter 17.82 - SP ZONE REQUIREMENTS AND STANDARDS FOR SPECIFIC PLAN NO. 293[[5]]

Footnotes:

--- ( 5 ) ---

Editor's note— Ord. No. 348.4851, § 2, adopted November 15, 2016, amended chapter 17.82 in its entirety to read as herein set out. Former chapter 17.82, §§ 17.82.010—17.82.230, pertained to similar subject matter. See Code Comparative Table and Disposition List for complete derivation.

Get a plain-English answer with a citation back to this text.

Ask AI about this code
Contents — Riverside County Zoning Code

GoCodebook provides public access, search, citation, multilingual explanation, and practical interpretation of legally adopted building regulations. It is not a substitute for the official ICC or California code publications.