Skip to content

Article III — ZONES, USES AND REQUIREMENTS›Division 11 — INDUSTRIAL ZONES

SEC. 16-170. INDUSTRIAL ACCESSORY USES: OFFICE USES.

Oxnard Zoning Code · 2026-06 edition · updated 2026-09-23 · Oxnard

Office uses as a principal use are permitted as indicated in section 16-163. Office uses in support of the principal industrial use in M-L, M-1, and M-2 zones are permitted as follows.

(A) In any freestanding building or divisible space, no more than 25% of the total gross floor area of any single or multi-tenant building shall be office area.

(B) Office areas above the 25% threshold may be permitted subject to the approval of a DDR permit. The city may require traffic and/or parking studies to determine the appropriateness of permitting office areas in excess of 25%. (Ord. No. 2958, 2985)

Get a plain-English answer with a citation back to this text.

Ask AI about this code
▸Contents — Oxnard Zoning Code
Oxnard Zoning Code
  1. Article I — GENERAL PROVISIONS
  2. Article II — DEFINITIONS
  3. ▸Article III — ZONES, USES AND REQUIREMENTS
  4. Article IV — STANDARDS FOR ALL ZONES
  5. Article V — SPECIFIC USE REQUIREMENTS
  6. Article VI — NONCONFORMING USES
  7. Article VII — PERMIT PROCEDURES
  8. Article VIII — CHANGE OF BOUNDARIES AND USES
  9. Article IX — ADVERTISING SIGNS
  10. Article X — OFF-STREET PARKING
  11. Article XI — SHORT-TERM RENTAL UNITS

GoCodebook provides public access, search, citation, multilingual explanation, and practical interpretation of legally adopted building regulations. It is not a substitute for the official ICC or California code publications.