Redwood City Municipal Code § 3.115 Measurement of Sign Area

Unless stated otherwise, the provisions of this Division apply to all signs regulated by this Article.

(Ord. No. 2309, § 2, 5-7-07)

The area of each sign shall be measured using the smallest geometric form, not to exceed six (6) straight sides, that encloses the extreme limits of copy together with any colors and graphics that are an integral part of the display. Framework, uprights, braces, pedestals, poles, non-structural trim and any other components that are not part of the sign face shall be included in the measurement of the sign only when they form an integral part of the message presentation or copy, as determined by the Director.

(Ord. No. 2309, § 2, 5-7-07)

Only one side of double-sided sign shall count as sign area provided the sign faces are parallel. If the faces of a double or multi-sided sign are angled from each other by forty-five (45) degrees or more, the display area of all sides shall be added together to yield the sign area.

(Ord. No. 2309, § 2, 5-7-07)

Unless otherwise provided, any sign which is located on a nonresidential property and which is subject to the permit requirement under this Article may be illuminated, provided that plans and details of the proposed illumination are submitted for review and approval by the City in accordance with the provisions of Division 3 of this Article.

(Ord. No. 2309, § 2, 5-7-07)

Each sign shall be constructed, installed and maintained in accordance with the provisions of this Article and all applicable Federal, State and local regulations including, but not limited to, compliance with the various safety codes.

(Ord. No. 2309, § 2, 5-7-07)