Title III›Division 1 — PLANNING›Part 2 — SPECIAL AREA COMBINING ZONES
34.1 S: DEVELOPMENT STANDARD COMBINING ZONE REGULATIONS
Humboldt County Zoning Code · 2026-07 edition · updated 2026-07-09 · Humboldt County
34.1.1 Title and Purpose. The provisions of this section shall be known as the Development Standard Combining Zone Regulations. The Development Standard Combining Zone Regulations are intended to allow modification of the specific development standards in the principal zones to more precisely implement the General Plan. (Former Section CZ#A313-41(A))
34.1.2 Applicability. The County Board of Supervisors, in approving a zone reclassification as allowed by Chapter 2 of this division, may include the “S” - “Development Standard Combining Zone” with any Principal Zone. By doing so, the Board of Supervisors may modify any or all of the following development standards: (Former Section CZ#A313-41(B))
34.1.2.1 Minimum Lot Size
34.1.2.2 Minimum Average Lot Size
34.1.2.3 Minimum Lot Width
34.1.2.4 Maximum Lot Depth
34.1.2.5 Minimum Yard Setbacks
34.1.2.6 Maximum Ground Coverage
34.1.2.7 Maximum Building Height
34.1.2.8 Permitted Principal Building Types
34.1.3 Limitations to Modifying Development Standards. Modifications of development standards are subject to the following limitations: (Former Section CZ#A313-41(C))
The Humboldt County Code is current through Ordinance 2784, passed March 10, 2026.
Page 177 of 1183
Title III Land Use and Development | Humboldt County Code
34.1.3.1 Minimum Lot Size shall not be modified below five thousand (5,000) square feet. (Former Section CZ#A313-41(C)(1))
34.1.3.2 Minimum Lot Width shall not be modified below fifty (50) feet. (Former Section CZ#A313-41(C)(2))
34.1.3.3 Principal Zones may be modified to allow manufactured homes as a permitted building type only when the zoning district to be modified will include a minimum area of four (4) acres or four (4) city blocks. (Former Section CZ#A313-41(C)(3))
34.1.4 Map Designation. When combined with a principal zone, the Development Standard Combining Zone shall be designated on the adopted zoning maps by the designator “S,” except as provided herein. The “S” designator shall immediately follow the principal zone designator, or, where applicable, shall immediately follow the maximum density designator. The development standards that are modified shall also be represented on the adopted zoning maps in a table format in the order listed in this section. Arabic numerals shall be used in the table to specify all modified development standards, except for permitted principal building types. Permitted building types shall be represented by name in the table. Minimum Lot Size shall be represented by a number which represents thousands of square feet, followed by the lower case letter “s,” or by a number which represents numbers of acres, followed by the lower case letter “a,” whichever is appropriate. For example: RS7.5s would require a minimum lot size of seven thousand five hundred (7,500) square feet. (Former Section CZ#A313-41(D))
Get a plain-English answer with a citation back to this text.
Ask AI about this code▸ Contents — Humboldt County Zoning Code
-
▸ Title III
Overview-
▸ Division 1 — PLANNING
Overview- Chapter 2 — ADMINISTRATION, PROCEDURES, AMENDMENTS AND ENFORCE…
- Chapter 1
- Chapter 2
- Chapter 3
- Part 1 — PRINCIPAL ZONES
-
▸ Part 2 — SPECIAL AREA COMBINING ZONES
Overview- 15.1 PURPOSE
- 15.2 APPLICABILITY
- 15.3 SPECIAL AREA COMBINING ZONES AND RESPECTIVE DESIGNATIONS
- 15.4 REPRESENTATION OF THE SPECIAL AREA COMBINING ZONES REGULA…
- 16.1 A: ARCHAEOLOGICAL RESOURCE AREA OUTSIDE SHELTER COVE
- 16.2 A: SPECIAL ARCHAEOLOGICAL RESOURCE AREA REGULATIONS FOR S…
- 16.3 AP: AIRPORT SAFETY REVIEW
- 18.1 C: COASTAL RESOURCE DEPENDENT
- 19.1 D: DESIGN REVIEW
- 20.1 E: COASTAL ELK HABITAT
- 21.1 F: FLOOD HAZARD AREAS
- 22.1 G: ALQUIST-PRIOLO FAULT HAZARD
- 28.1 M: MANUFACTURED HOMES
- 29.1 N: NOISE IMPACT
- 30.1 O: OFFSHORE ROCKS AND ROCKY INTERTIDAL AREAS
- 31.1 P: PLANNED UNIT DEVELOPMENT
- 32.1 Q: QUALIFIED
- 33.1 R: STREAMS AND RIPARIAN CORRIDORS PROTECTION
- 34.1 S: DEVELOPMENT STANDARD COMBINING ZONE REGULATIONS
- 34.2 SM: MODIFIED BUILDING STANDARDS INCLUDING PROVISION FOR M…
- 34.3 SX: DEVELOPMENT STANDARDS WHICH ARE COMBINED WITH A PROHI…
- 34.4 SY: DEVELOPMENT STANDARDS WHERE STANDARDS IN ADDITION TO …
- 34.5 STMP: SAMOA TOWN PLAN STANDARDS
- 35.1 T: TRANSITIONAL AGRICULTURAL LANDS
- 38.1 W: COASTAL WETLAND AREAS
- 39.1 X: NO FURTHER SUBDIVISION ALLOWED
- 40.1 Y: SPECIFIED MINIMUM AND AVERAGE LOT SIZES
- Part 1 — USES AND ACTIVITIES
- Part 2 — STRUCTURES AND FACILITIES
- Part 3 — DEVELOPMENT STANDARDS
- Part 4 — REGULATIONS THAT APPLY IN SENSITIVE HABITATS AND HAZA…
- Part 5 — NONCONFORMING USES AND STRUCTURES
- Part 1 — CLASSIFICATION OF USE TYPES
- Part 2 — GLOSSARY OF USE TYPES
- Part 1 — PRINCIPAL ZONES
- Part 2 — REGULATIONS FOR THE COMBINING ZONES
- Part 1 — USES AND ACTIVITIES
- Part 2 — STRUCTURES AND FACILITIES
- Part 3 — DEVELOPMENT STANDARDS
- Part 4 — (SECTION RESERVED FOR FUTURE USE)
- Part 5 — NONCONFORMING USES AND STRUCTURES
- Part 1 — CLASSIFICATION OF USE TYPES
- Part 2 — GLOSSARY OF USE TYPES
-
- Title III — LAND USE AND DEVELOPMENT