§ 17.32 — Fort Jones Planning Code

Sec. 17.32.010. - Standards and specifications.¶

Those regulations which shall apply to hillside areas are set forth in the following table:

TABLE 17.32.010
Lot Sizes by Type and Improvements Required
Hillside areas** (Minor street widths)
Lots	Type I	Type II	Type III	Type IV
Area, average min.	6,000 sq. ft. min.	10,000 sq. ft.	20,000 sq. ft.	40,000 sq. ft.
Frontage, minimum	60 ft. except 30 ft. at end of cul-de-sac	80 ft. except 40 ft. at end of cul-de-sac	100 ft. except at end of cul-de-sac	150 ft. except 75 ft. at end of cul-de-sac
Width, average min.	60 feet	80 feet	90 feet	100 feet
Street Design
R.O.W. width	60 ft. min.	60 ft. min.	50 ft. min.	50 ft. min.
Pavement width	40 ft. or two 20 ft.	40 ft. or two 18 ft.	26 ft. or two 18 ft.	24 ft.
Cul-de-sac or Loop St.

R.O.W. width	50 ft. or 56 ft.	50 ft.	50 ft.	40 ft.
Pavement width	36 ft.	32 ft.	26 ft.	24 ft.
Curb and Gutter	Roll	Roll
	Concrete curb and gutter except corners	Concrete curb and gutter except std. curb at corners	Concrete curb and gutter	Concrete curb and gutter
Slope
Maximum Cross ** Slope on which this Type is permitted	Up to 20%	Up to 25%	Up to 30% over on approval of P.C.	Up to 40% over on approval of PC
Notes to Table 17.32.010:
* Twenty percent of the lots in any hillside subdivision (not including lots at end of cul-de-sacs) may have reduced frontage; provided, that such reduction is not below the requirements of the next least restrictive type or classifcation of subdivision
** Grading restrictions, not more than ten percent of area lot to be left in slope steeper than original ground or steeper than 25 percent, whichever is greater

** Grading restrictions, not more than ten percent of area lot to be left in slope steeper than original ground or steeper than 25 percent, whichever is greater

(Code 1987, § 17.32.010; Ord. No. 23-1974, § 15, 1974)

CHAPTER 17.36. - IMPROVEMENTS