Skip to content

Lompoc · Zoning · MU

Lompoc MU zoning: height, setbacks and lot size

In Lompoc's MU zone, generally buildings can be up to 45 ft tall, the front setback is No minimum and the minimum lot size is 7,000 sq ft, with the conditions listed below (Lompoc code, read October 2026).

Key points

  • Maximum building height: 45 ft (Main/primary building)
  • Minimum front setback: No minimum
  • Minimum side setback: No minimum
  • Minimum rear setback: 10 ft (The review authority may reduce it if there is room for waste receptacles and equipment storage and access.)
  • Minimum lot size: 7,000 sq ft
  • Maximum density: 44 dwelling units/net acre (Projects that are all residential (no commercial uses and not mixed use))

MU is a zoning district in Lompoc. Every value below was read from the Lompoc Municipal Code and links to its section (read October 2026). State laws such as the ADU and SB 9 rules can allow more on a residential lot. General information, not legal advice — read the code text and check with the city before you build.

Development standards in MU

The general rule for a typical lot in this zone. Zoning tables often attach notes, such as rules for corner lots, lots next to a residential zone, or new subdivisions only. Open “code text” under a value to see the table cell or sentence it was read from.

Maximum building height
45 ft
Applies: Main/primary building
§ 17.220.040 · code text
Table row “Height (max.)”, column “MU”: 45 ft.
Minimum front setback
No minimum
§ 17.220.040 · code text
Table row “Front (min.)”, column “MU”: -
Minimum side setback
No minimum
§ 17.220.040 · code text
Table row “Side - Interior (min.)”, column “MU”: -
Minimum rear setback
10 ft
Applies: The review authority may reduce it if there is room for waste receptacles and equipment storage and access.
§ 17.220.040 · code text
Table row “Rear (min.)”, column “MU”: 10 ft. 4
Minimum lot size
7,000 sq ft
§ 17.220.040 · code text
Table row “Lot Area (min.)”, column “MU”: 7,000 s.f.
Maximum density
44 dwelling units/net acre
Applies: Projects that are all residential (no commercial uses and not mixed use)
§ 17.220.040 · code text
Table row “Density (max.)”, column “MU”: 44 dwelling units/net acre

Uses in MU

Uses the code's use tables allow in MU, or allow with a permit. Each links to its page with the code section.

When a different number applies

The code sets other values for particular lots, buildings or locations in MU:

  • Maximum floor area ratio (FAR): 0.75 — All commercial § 17.220.040
  • Maximum floor area ratio (FAR): 1.5 — Mixed use, with 75% of floor area for residential uses § 17.220.040

Not on this page

We did not find a general stories, lot coverage, FAR limit for MU in the zoning tables we read. The code may still set one elsewhere — check the Lompoc Municipal Code.

Other Lompoc zoning districts

Who this affects

HomeownersArchitects and designersDevelopersReal estate agents

Frequently asked questions

What is the maximum building height in Lompoc's MU zone?

45 ft (main/primary building) — Lompoc Municipal Code § 17.220.040.

What is the minimum front setback in Lompoc's MU zone?

No minimum — Lompoc Municipal Code § 17.220.040.

What is the minimum side setback in Lompoc's MU zone?

No minimum — Lompoc Municipal Code § 17.220.040.

What is the minimum rear setback in Lompoc's MU zone?

10 ft (the review authority may reduce it if there is room for waste receptacles and equipment storage and access) — Lompoc Municipal Code § 17.220.040.

What is the minimum lot size in Lompoc's MU zone?

7,000 sq ft — Lompoc Municipal Code § 17.220.040.

General information, not legal advice.

Ask about a Lompoc property in MU

Ask GoCodebook what you can build at a specific address and get an answer that cites the section.

Ask your question

More on Lompoc