Skip to content

Lompoc · Zoning · BP

Lompoc BP zoning: height, setbacks and lot size

In Lompoc's BP zone, generally buildings can be up to 35 ft tall, the front setback is 10 ft and the minimum lot size is 2 acres, with the conditions listed below (Lompoc code, read October 2026).

Key points

  • Maximum building height: 35 ft
  • Minimum front setback: 10 ft
  • Minimum side setback: 5 ft
  • Minimum rear setback: 5 ft
  • Minimum lot size: 2 acres (Subdivisions that create lots under 10 acres also need design and site development review approval.)
  • Maximum lot coverage: No standard
  • Maximum floor area ratio (FAR): 0.75

BP is a zoning district in Lompoc. Every value below was read from the Lompoc Municipal Code and links to its section (read October 2026). State laws such as the ADU and SB 9 rules can allow more on a residential lot. General information, not legal advice — read the code text and check with the city before you build.

Development standards in BP

The general rule for a typical lot in this zone. Zoning tables often attach notes, such as rules for corner lots, lots next to a residential zone, or new subdivisions only. Open “code text” under a value to see the table cell or sentence it was read from.

Maximum building height
35 ft
§ 17.216.040 · code text
Table row “Height (max.)”, column “BP”: 35 ft.; 18 ft. adjacent to the boundary of Lompoc Airport 3
Minimum front setback
10 ft
§ 17.216.040 · code text
Table row “Front (min.)”, column “BP”: 10 ft. 2
Minimum side setback
5 ft
§ 17.216.040 · code text
Table row “Side - Interior (min.)”, column “BP”: 5 ft. 2
Minimum rear setback
5 ft
§ 17.216.040 · code text
Table row “Rear (min.)”, column “BP”: 5 ft. 2
Minimum lot size
2 acres
Applies: Subdivisions that create lots under 10 acres also need design and site development review approval.
§ 17.216.040 · code text
Table row “Lot Area (min.)”, column “BP”: 2 acres 1
Maximum lot coverage
No standard
§ 17.216.040 · code text
Table row “Lot Coverage (max.)”, column “BP”: -
Maximum floor area ratio (FAR)
0.75
§ 17.216.040 · code text
Table row “Floor Area Ratio (max.)”, column “BP”: 0.75

Uses in BP

Uses the code's use tables allow in BP, or allow with a permit. Each links to its page with the code section.

When a different number applies

The code sets other values for particular lots, buildings or locations in BP:

  • Maximum building height: 18 ft — Adjacent to the boundary of Lompoc Airport; unless more restrictive height standards are required by the Airport Master Plan. § 17.216.040

Not on this page

We did not find a general stories, density limit for BP in the zoning tables we read. The code may still set one elsewhere — check the Lompoc Municipal Code.

Other Lompoc zoning districts

Who this affects

HomeownersArchitects and designersDevelopersReal estate agents

Frequently asked questions

What is the maximum building height in Lompoc's BP zone?

35 ft — Lompoc Municipal Code § 17.216.040.

What is the minimum front setback in Lompoc's BP zone?

10 ft — Lompoc Municipal Code § 17.216.040.

What is the minimum side setback in Lompoc's BP zone?

5 ft — Lompoc Municipal Code § 17.216.040.

What is the minimum rear setback in Lompoc's BP zone?

5 ft — Lompoc Municipal Code § 17.216.040.

What is the minimum lot size in Lompoc's BP zone?

2 acres (subdivisions that create lots under 10 acres also need design and site development review approval) — Lompoc Municipal Code § 17.216.040.

General information, not legal advice.

Ask about a Lompoc property in BP

Ask GoCodebook what you can build at a specific address and get an answer that cites the section.

Ask your question

More on Lompoc