Skip to content

Jurupa Valley · Zoning · R-2A

Jurupa Valley R-2A zoning: height, setbacks and lot size

In Jurupa Valley's R-2A zone, buildings can be up to 30 ft (2 stories) tall, the front setback is 20 ft and the minimum lot size is 7,200 sq ft (Jurupa Valley code, read October 2026).

Key points

  • Maximum building height: 30 ft
  • Maximum number of stories: 2 stories
  • Minimum front setback: 20 ft
  • Minimum side setback: 5 ft
  • Minimum rear setback: 10 ft
  • Minimum lot size: 7,200 sq ft
  • Maximum lot coverage: 60%

R-2A (Limited Multiple-Family Dwellings) is a zoning district in Jurupa Valley. Every value below was read from the Jurupa Valley Municipal Code and links to its section (read October 2026). State laws such as the ADU and SB 9 rules can allow more on a residential lot. General information, not legal advice — read the code text and check with the city before you build.

Development standards in R-2A

The general rule for a typical lot in this zone. Zoning tables often attach notes, such as rules for corner lots, lots next to a residential zone, or new subdivisions only. Open “code text” under a value to see the table cell or sentence it was read from.

Maximum building height
30 ft
§ 9.75.030 · code text
Building height shall not exceed two (2) stories of thirty (30) feet.
Maximum number of stories
2 stories
§ 9.75.030 · code text
Building height shall not exceed two (2) stories of thirty (30) feet.
Minimum front setback
20 ft
§ 9.75.050 · code text
A. Front yard, twenty (20) feet.
Minimum side setback
5 ft
§ 9.75.050 · code text
B. Interior side yard, five (5) feet.
Minimum rear setback
10 ft
§ 9.75.050 · code text
D. Rear yard, ten (10) feet. For through lots, rear yard twenty (20) feet.
Minimum lot size
7,200 sq ft
§ 9.75.040 · code text
Lot area shall not be less than seven thousand two hundred (7,200) square feet.
Maximum lot coverage
60%
§ 9.75.060 · code text
In no case shall more than sixty (60) percent of any lot be covered by buildings.

When a different number applies

The code sets other values for particular lots, buildings or locations in R-2A:

  • Minimum rear setback: 20 ft — For through lots § 9.75.050

Not on this page

We did not find a general FAR, density limit for R-2A in the zoning tables we read. The code may still set one elsewhere — check the Jurupa Valley Municipal Code.

Other Jurupa Valley zoning districts

Who this affects

HomeownersArchitects and designersDevelopersReal estate agents

Frequently asked questions

What is the maximum building height in Jurupa Valley's R-2A zone?

30 ft — Jurupa Valley Municipal Code § 9.75.030.

What is the maximum number of stories in Jurupa Valley's R-2A zone?

2 stories — Jurupa Valley Municipal Code § 9.75.030.

What is the minimum front setback in Jurupa Valley's R-2A zone?

20 ft — Jurupa Valley Municipal Code § 9.75.050.

What is the minimum side setback in Jurupa Valley's R-2A zone?

5 ft — Jurupa Valley Municipal Code § 9.75.050.

What is the minimum rear setback in Jurupa Valley's R-2A zone?

10 ft — Jurupa Valley Municipal Code § 9.75.050.

General information, not legal advice.

Ask about a Jurupa Valley property in R-2A

Ask GoCodebook what you can build at a specific address and get an answer that cites the section.

Ask your question

More on Jurupa Valley