Article III — ZONES, USES AND REQUIREMENTS›Division 18 — LOT SIZE ADDITIVE
SEC. 16-287. LOT SIZE ADDITIVE; EFFECT.
Oxnard Zoning Code · 2026-06 edition · updated 2026-09-23 · Oxnard
A lot size additive may be added as a suffix to any of the basic underlying zones to establish a minimum lot area, minimum lot width, and side yard setback. The minimum requirements as set forth in section 16-288 shall apply rather than the lot area, width and setback provisions of the basic underlying zone. All requirements other than the lot area, lot width, and side yard setback shall be as specified in the provisions for the basic underlying zone. (`64 Code, Sec. 34-111.06) (Ord. No. 1793)
Get a plain-English answer with a citation back to this text.
Ask AI about this code▸Contents — Oxnard Zoning Code
- Article I — GENERAL PROVISIONS
- Article II — DEFINITIONS
▸Article III — ZONES, USES AND REQUIREMENTS
Overview- Division 1 — GENERALLY
- Division 2 — RESIDENTIAL ZONES
- Division 4 — [RESERVED]
- Division 7 — COMMERCIAL ZONES
- Division 10 — DOWNTOWN ZONES
- Division 11 — INDUSTRIAL ZONES
- Division 12 — (RESERVED)
- Division 13 — (RESERVED)
- Division 14 — (RESERVED)
- Division 15 — (RESERVED)
- Division 16 — C-R COMMUNITY RESERVE ZONE
- Division 17 — PLANNED DEVELOPMENT (ADDITIVE) ZONE
- Division 19 — AIRPORT HAZARD OVERLAY ZONE
- Article IV — STANDARDS FOR ALL ZONES
- Article V — SPECIFIC USE REQUIREMENTS
- Article VI — NONCONFORMING USES
- Article VII — PERMIT PROCEDURES
- Article VIII — CHANGE OF BOUNDARIES AND USES
- Article IX — ADVERTISING SIGNS
- Article X — OFF-STREET PARKING
- Article XI — SHORT-TERM RENTAL UNITS