Skip to content

Colusa · Zoning · R-1

Colusa R-1 zoning: height, setbacks and lot size

In Colusa's R-1 zone, buildings can be up to 35 ft tall, the front setback is 20 ft and the minimum lot size is 8,000 sq ft (Colusa code, read October 2026).

Key points

  • Maximum building height: 35 ft
  • Minimum front setback: 20 ft
  • Minimum side setback: 5 ft on one side and 10% of lot width on the other side, with total not exceeding 15 ft (Interior lots)
  • Minimum rear setback: 20% of lot depth, min 15 ft, max 30 ft
  • Minimum lot size: 8,000 sq ft
  • Maximum lot coverage: 35%

R-1 (Single Family Residence District) is a zoning district in Colusa. Every value below was read from the Colusa Municipal Code and links to its section (read October 2026). State laws such as the ADU and SB 9 rules can allow more on a residential lot. General information, not legal advice — read the code text and check with the city before you build.

Development standards in R-1

The general rule for a typical lot in this zone. Zoning tables often attach notes, such as rules for corner lots, lots next to a residential zone, or new subdivisions only. Open “code text” under a value to see the table cell or sentence it was read from.

Maximum building height
35 ft
§ 5.05 · code text
Building Height Limit: Two and one-half stories, but not to exceed thirty-five feet.
Minimum front setback
20 ft
§ 5.05 · code text
Front Yard Setback: Twenty feet.
Minimum side setback
5 ft on one side and 10% of lot width on the other side, with total not exceeding 15 ft
Applies: Interior lots
§ 5.05 · code text
Interior Lots: Each interior side yard shall be not less than five feet on one side and ten percent of the lot width on the other side, but the total of both need not exceed fifteen feet.
Minimum rear setback
20% of lot depth, min 15 ft, max 30 ft
§ 5.05 · code text
Rear Yard Setback: Twenty percent of the lot depth; may not be less than fifteen feet, need not exceed thirty feet.
Minimum lot size
8,000 sq ft
§ 5.05 · code text
Lot Area: Eight thousand square feet.
Maximum lot coverage
35%
§ 5.05 · code text
Maximum Main Building Coverage: Thirty-five percent of lot area.

When a different number applies

The code sets other values for particular lots, buildings or locations in R-1:

  • Minimum side setback: 15% of lot width, max 15 ft — Street side of a corner lot § 5.05
  • Minimum side setback: 5 ft — Interior side yard on a corner lot § 5.05

Not on this page

We did not find a general stories, FAR, density limit for R-1 in the zoning tables we read. The code may still set one elsewhere — check the Colusa Municipal Code.

Other Colusa zoning districts

Who this affects

HomeownersArchitects and designersDevelopersReal estate agents

Frequently asked questions

What is the maximum building height in Colusa's R-1 zone?

35 ft — Colusa Municipal Code § 5.05.

What is the minimum front setback in Colusa's R-1 zone?

20 ft — Colusa Municipal Code § 5.05.

What is the minimum side setback in Colusa's R-1 zone?

5 ft on one side and 10% of lot width on the other side, with total not exceeding 15 ft (interior lots) — Colusa Municipal Code § 5.05.

What is the minimum rear setback in Colusa's R-1 zone?

20% of lot depth, min 15 ft, max 30 ft — Colusa Municipal Code § 5.05.

What is the minimum lot size in Colusa's R-1 zone?

8,000 sq ft — Colusa Municipal Code § 5.05.

General information, not legal advice.

Ask about a Colusa property in R-1

Ask GoCodebook what you can build at a specific address and get an answer that cites the section.

Ask your question

More on Colusa