Chapter 66 — SPECIAL SAFETY PROVISIONS

Rebound tumbling equipment, as used in this chapter and Section 107, is a fabric bed or surface designed to provide resilience by virtue of its own elasticity or that provided by an elastic or spring suspension system, or by both, within a stable and tested frame that is intended to be used for jumping, bouncing or acrobatic tumbling.

6604 – REBOUND TUMBLING CENTER

Downloaded from https://ecode360.com/PA4578 on 2026-07-07

City of Palmdale, CA

PALMDALE CODE

§ 8.04.250

§ 8.04.250

Rebound tumbling center, as used in this chapter, is a place where rebound tumbling equipment is provided and maintained for public use.

Rebound tumbling equipment shall be located on a level surface in such a way as to be within view of the operator or attendant at all times. The spacing of equipment units shall conform to the following minimum dimensions as measured from the inside edge of the frame:

1. Three feet (914 mm) between sides of units.

2. Four feet (1219 mm) between ends of units.

3. Five feet (1524 mm) from ends to nearest fence, building or other similar construction.

4. Three feet (914 mm) from sides or corners to nearest fence, building or other similar construction.

The area surrounding the rebound tumbling equipment shall be surfaced to prevent a dust nuisance and shall have a reasonably level surface of pea gravel or equivalent type of material from a safety and dust-control standpoint.

Pits for rebound tumbling centers shall be so constructed that they will not interfere with the operation of the equipment and that they be of a depth not less than 3 feet (914 mm) or more than 4 feet (1219 mm) at centers. Such pits shall be so framed that the rebound tumbling equipment is held in a level position and is supported on a solid stable surface. Lumber used as framing for pits shall not be less than 2 inches (51 mm) in thickness and shall be securely connected together.

6607 – CONSTRUCTION OF EQUIPMENT

Precautionary measures shall be taken to prevent broken springs on rebound tumbling equipment from disengaging from the assembly.

6608 – USE OF PADDING

The frames of rebound tumbling equipment shall be completely padded to provide reasonable safety. Pads 2 inches (51 mm) thick filled with cotton liners shall be deemed to meet this requirement.

The entire rebound tumbling center shall be completely enclosed by fencing not less than 5 feet (1524 mm) in height.

6610 – INSPECTION

The Building Official shall inspect annually every rebound tumbling center.

6611 – AUTOMOBILE RACING FACILITIES

A new Chapter 67, Security Provisions, is adopted as the security provisions of the Palmdale Building Code, to read and be cited as follows: