Skip to content

Article IV — STANDARDS FOR ALL ZONES›Division 1 — GENERAL REQUIREMENTS

SEC. 16-311. FENCE LIMITATIONS, INDUSTRIAL ZONE.

Oxnard Zoning Code · 2026-06 edition · updated 2026-09-23 · Oxnard

(A) Unless the fence is reviewed and approved by means of a special use permit, planned development permit or development plan granted pursuant to this chapter, the following fence limitations shall apply to all industrial zones:

(1) Height - No fence shall exceed eight feet in height as measured from the grade of the enclosed lot.

(2) Street-fence setback area - For any lot for which a building setback is imposed pursuant to this chapter, the street-fence setback line shall be of an equal distance and no fence shall be located in the street-fence setback area.

(B) For any lot for which no building setback is imposed pursuant to this chapter, the street-fence setback line shall be ten feet and no fence shall be located in the street-fence setback area.

(`64 Code, Sec. 34-22.9) (Ord. No. 1899)

Get a plain-English answer with a citation back to this text.

Ask AI about this code
▸Contents — Oxnard Zoning Code
Oxnard Zoning Code
  1. Article I — GENERAL PROVISIONS
  2. Article II — DEFINITIONS
  3. Article III — ZONES, USES AND REQUIREMENTS
  4. ▸Article IV — STANDARDS FOR ALL ZONES
  5. Article V — SPECIFIC USE REQUIREMENTS
  6. Article VI — NONCONFORMING USES
  7. Article VII — PERMIT PROCEDURES
  8. Article VIII — CHANGE OF BOUNDARIES AND USES
  9. Article IX — ADVERTISING SIGNS
  10. Article X — OFF-STREET PARKING
  11. Article XI — SHORT-TERM RENTAL UNITS

GoCodebook provides public access, search, citation, multilingual explanation, and practical interpretation of legally adopted building regulations. It is not a substitute for the official ICC or California code publications.