Mammoth Lakes Municipal Code Ch. 17.28 Industrial Zoning District

In addition to the objectives outlined in Section 17.04.010, the specific purposes of the industrial zoning district are to:

(1) To reserve appropriately located areas for viable industrial uses and protect these areas from intrusion by family dwellings or other incompatible uses.

(2) To protect residential and commercial uses from noise, odor, dust, smoke, truck traffic and other objectionable influences incidental to certain industrial uses.

(3) To protect industrial uses and structures from hazard and to minimize the impact of industrial uses on the environment.

(4) To minimize traffic congestion and to avoid the overloading of utilities by restricting the construction of buildings of excessive size in relation to the amount of land around them.

(5) Provide an area for light industrial and limited service type uses located so as to minimize impacts on adjacent land use patterns and the environment and with development standards to facilitate relocation of existing nonconforming industrial/service uses in commercial zones to designated industrial areas.

(Code 1990, § 17.28.010; Ord. No. 14-02, § 4, 3-19-2014)

(a) General permit requirements. Table 17.28.020 identifies the uses of land allowed by this chapter in the industrial zoning district, and the permit required to establish each use, in compliance with Section 17.08.020.

(b) Requirements for certain specific land uses. Where the last column in Table 17.28.020 includes a section number, the referenced section may establish other requirements and standards applicable to the use. The following is a key for the abbreviations used in Table 17.28.020:

Table 17.28.020 Allowed Uses and Permit Requirements for the Industrial Zoning District

(Code 1990, § 17.28.020; Ord. No. 14-02, § 4, 3-19-2014; Ord. No. 15-01, § 4(exh. A, § 5), 1-21-2015; Ord. No. 16-04, § 2b(exh. A), 5-18-2016; Ord. No. 18-02, § 5(exh. A, b.), 3-13-2018)

Subdivisions, new land uses and structures, and alterations to existing land uses and structures, shall be designed, constructed, or established in compliance with the requirements in Table 17.28.030, in addition to the applicable development standards (e.g., landscaping, parking and loading, etc.) in Chapters 17.36 through 17.56. Additional regulations are denoted in the right column. Section numbers refer to other sections of this chapter.

Table 17.28.030. Planning and Building Standards Development Feature Planning

(Code 1990, § 17.28.030; Ord. No. 14-02, § 4, 3-19-2014)