§ 9103.05 — Arcadia Zoning Code

9103.05.010 - Purpose and Intent. ¶

A.

This Section establishes standards and regulations for the construction and maintenance of fences, walls, and gates, as the terms are defined in Division 9 (Definitions). The standards are intended to ensure that these types of structures provide the desired privacy and safety while avoiding becoming a public safety hazard or nuisance.

B.

For Specific Plans and Planned Developments, fence and wall heights shall comply with the standards contained within the applicable Specific Plan or Planned Development. Where the Specific Plan or Planned Development is silent with regard to fence and wall height, the standards for the zone that most closely reflects the Specific Plan or the Planned Development shall apply, as determined by the Director.

9103.05.020 - Permit Requirements. ¶

Construction of new fences, walls, and gates shall be subject to Site Plan and Design Review according to Section 9107.19 (Site Plan and Design Review).

9103.05.030 - Development Standards. ¶

General.

1.

The fence or wall height shall be measured from the lowest adjacent grade to the uppermost part of the fence or wall. Refer to Figure 3-7 (Fence Height Measurement).

2.

When there is a full landscaped parkway with no sidewalk, a fence and/or columns, excluding vehicular entry gate(s), may be placed adjacent to the front property line.

3.

The need for any retaining walls and/or fences, and their heights, shall be determined by the Director and the Building Official through the Site Plan Review process. An administrative modification is not required for retaining walls and/or fences where there is a grade difference between the abutting property.

4.

Temporary construction fencing that is of chain link or wire type may be allowed within the front and street side setback areas, provided it does not exceed six feet in height.

5.

All fences, walls, and gates shall be subject to the height limitations described in Section 9103.01.070 (Vehicular Visibility Standards) of this Development Code.

Figure 3-7

Fence Height Measurement

==> picture [180 x 153] intentionally omitted <==

B.

Fence Height with Difference in Grade. Where there is a difference in a grade between properties, a fence, wall, or gate may be a maximum height of six feet adjacent to the rear and property lines if such fence, wall, or gate maintains a minimum setback that is equal to the difference in grade between the properties. See Figure 3-8 (Fence Height Measurement with a Difference in Grade). In all other situations, the wall height shall comply with the provisions of this Section.

Figure 3-8 Fence Height Measurement with a Difference in Grade

==> picture [240 x 167] intentionally omitted <==

C.

Residential Zones.

1.

Fences, Walls, and Gates Located in the Front Setback.

a.

The required setbacks, height dimensions, and spacing for fences, walls, and gates shall be as indicated in Table 3-2 (Fences, Walls, and Gates) and Figure 3-9 (Fences, Walls, and Gates).

Table 3-2 Fences, Walls, and Gates -	Front Setback	Front Setback	Front Setback
Front Setbacks	Regulations within Each Residential Zone
	Zones
Requirement	R-M	R-0	R-1	R-2	R-3	R-3-R
Setbacks
Decorative fences, columns, and caps	3 ft minimum from property line					Fences, walls, and/or vehicular gates prohibited within front and street side setbacks.(1)
Vehicular entry gates and pilasters	4 ft minimum from the property line
Height

Decorative fences, columns, and caps:	4 ft maximum	4 ft maximum (N of Hugo Reid Drive) 3 ft maximum (S of Hugo Reid Drive)	3 ft maximum	4 ft maximum (2)	4 ft maximum (2)	3 ft maximum(3)
Pedestrian entry gates, vehicular entry gates, and pilasters:	4 ft maximum	5 ft max (N of Hugo Reid Drive) 4 ft maximum (S of Hugo Reid Drive)	4 ft maximum	4 ft maximum (2)	4 ft maximum (2)	3 ft maximum(3)
Decorative lights, limited to entry points at pedestrian and vehicular entry gates	18 inches above the maximum fence/column height					—
Decorative outdoor post mounted light fxture	8 ft maximum					—
Dimensions and Spacing
Distance between decorative columns for a pedestrian entry gate.	4 ft minimum 8 ft maximum					—
Horizontal intervals of columns and posts	8 ft minimum					—
Dimension of columns and posts	24 inches maximum					—
Dimensions of caps	30 inches by 30 inches maximum					—
Garden arbor or pergola over a pedestrian walkway (allowed within the front setback area)	8 ft height maximum			—	—	—
Notes: (1) Except for guard rails and hand rails required for safety protection, or for reasonable accommodation (ADA) purposes, up to the minimum height required by the Building Code. (2) Applicable to properties with multifamily dwelling units that face the street-side of a lot. (3) Temporary construction fencing that is of chain link or wire type may be allowed within the front street and side setback areas, provided it does not exceed six feet in height. (4) For fences, walls, and gates in side and rear setback areas, see Subsection 9103.05.030 C.5 (Fences, Walls, and Gates—Side and Rear Setback Areas).

Figure 3-9 Fences, Walls, and Gates

==> picture [288 x 205] intentionally omitted <==

2.

Special Regulations for Fences, Walls, and Gates Located in the Front Setback—Residential Zones.

R-M and R-0 Zones.

(1)

A solid wall adjacent to the interior side property line may be allowed in the front setback area, provided that it does not exceed four feet in height.

(2)

Only one pedestrian gate with decorative columns shall be allowed within the front setback area.

(3)

All fences shall be of open work design (a minimum of four inches between vertical and horizontal members). A two-foot high solid wall may be combined within the allowed height of the decorative fence. Refer to Figure 3-10 (Fence in R-M and R-0 Zones).

Figure 3-10 Fence in R-M and R-0 Zones

==> picture [264 x 120] intentionally omitted <==

R-1 Zone.

(1)

All fences shall be of open work design (a minimum of four inches between vertical and horizontal members). A solid decorative masonry base for fences may be allowed in the front setback area, provided that it does not exceed eight inches in height. Refer to Figure 3-11 (Fence in R-1 Zone).

Figure 3-11

Fence in R-1 Zone

==> picture [276 x 102] intentionally omitted <==

(2)

A solid wall adjacent to the interior side property line may be allowed in the front setback area, provided that it does not exceed three feet in height.

(3)

Only one pedestrian gate with decorative columns shall be allowed within the front setback area.

3.

Fences, Walls, and Gates—Corner Lots.

a.

All fences, walls, or gates, including height, design, and location within the street side setback or special setback area, shall be subject to Site Plan and Design Review pursuant to requirements Section 9107.19 (Site Plan and Design Review) in the R-2 and R-3 zones.

b.

On corner lots, fences, walls, and gates within the required street side setback or special setback are allowed up to six feet in height, measured at the street side property line, except as restricted by Subsection 9103.01.070 (Vehicular Visibility Standards).

c.

Fences, walls, and gates shall be setback a minimum of 18 inches from the street side property line.

d.

The area between the street side property line and the fence, wall, or gate shall have an appropriate irrigation system and decorative landscaping (shrubs, ground cover, flowers, plants, etc.). However, when there is a full landscaped parkway with no sidewalk, a fence, wall, and gate, excluding entry gate(s), may be placed to the street side property line in R-M, R-0, and R-1 Zones.

4.

Fences, Walls, and Gates—Flag Lots.

a.

Fences, walls, and gates on flag lots shall not be allowed in R-2, R-3-R, and R-3 zones.

b.

In areas zoned R-M and R-0, a fence or wall may be allowed in the front setback and driveway area, provided that it does not exceed four feet in height. In the R-1 zone, the height shall not exceed three feet.

c.

Where a fence or wall is located within the front setback of a flag lot and the front property line of that flag lot abuts the rear property line of an adjacent lot, it may be allowed up to six feet in height. See Figure 3-12 (Fences and Walls on Flag Lots).

Figure 3-12

Fences and Walls on Flag Lots

==> picture [288 x 283] intentionally omitted <==

5.

Fences, Walls, and Gates—Side and Rear Setback Areas.

a.

Fences, walls, and gates located within a required side and/or rear setback area(s) are allowed up to six feet in height, provided that no portion of any such fence, wall, or gate extends into the required front setback area.

b.

Where there is a difference in grade between properties, a wall or fence is allowed up to six feet in height adjacent to the rear and side property lines if the wall or fence maintains a minimum setback that is equal to the difference in grade between the properties. Where there is no difference in grade between properties, a wall shall comply with the height limitations unless it complies with the setbacks required for an accessory building. Refer to Figure 3-13 (Fences Walls and Gates with a Grade Difference). However, if the grade has been altered due to previous grading, the finished grade shall be subject to review and approval by the Director.

c.

Fences and walls are allowed adjacent to the property line in the side and rear setback areas.

Figure 3-13

Fences Walls and Gates with a Grade Difference

==> picture [216 x 159] intentionally omitted <==

6.

Walls for Tennis Courts.

a.

A six-foot high solid masonry wall shall be installed on the property lines between the tennis court and adjacent properties. In the R-M, R-0 and R-1 zones, where the entire side of a tennis court is a minimum distance of 25 feet from a property line, a six-foot high solid masonry wall shall not be required along the property line.

D.

Commercial Zones.

Fences, walls, and gates shall not exceed three (3) feet along the front property line and must be of an open design. Any gate placed across a court setback opening or a fence around an outdoor dining area shall have a minimum of 50 percent transparency.

2.

Fences and walls located at rear and interior side setback areas are limited to six feet in height.

(Ord. No. 2347, § 4(Exh. B), 6-6-17; Ord. No. 2401, Exh. B, 4-15-25)

9103.05.040 - Prohibited Fencing Materials in All Zones.

A.

No spears (apache, aristocrat with crushed spears, or any spear-like features) shall be allowed on a fence, wall, or gate.

B.

Chain link, corrugated fiberglass, bamboo fencing, and wire type fencing shall not be allowed, except chain link fencing is allowed as a fencing material enclosing sports courts and temporary construction fencing.

Section 9103.07 - Off-Street Parking and Loading

9103.07.010 - Purpose and Intent.

This Section establishes regulations to:

A.

Regulate off-street parking and loading to minimize traffic congestion and hazards to motorists, bicyclists, and pedestrians;

B.

Provide off-street parking in proportion to the needs generated by different land uses;

C.

Ensure access to projects by emergency response vehicles; and

D.

Ensure that parking areas are designed to operate efficiently and effectively and in a manner compatible with on-site and surrounding land uses.