Chapter 6 — DESIGN STANDARDS — Agoura Hills Municipal Code

- Lot standards.

All lots created by the subdivision of land shall access to a public street which has been improved and which street meets the standards set forth in this chapter. All lots shall conform to the requirement of the zoning district in which the proposed project is located. The minimum width of a lot shall be approximately at right angles to the street line on straight streets or to the tangent on curved streets. Whenever the public necessity, convenience or general welfare so require, the city council or planning commission may waive the requirements of this section.

(Ord. No. 125, 6-2-87)

- Street standards.

All residential, industrial, and commercial streets shall be in conformance with the city's circulation element of the general plan which is in effect at the time of submittal of the tentative map.

(Ord. No. 125, 6-2-87)

- Street names and numbers.

Street names shall be approved by the planning director. Street numbers shall be assigned by the department of building and safety.

(Ord. No. 125, 6-2-87)

- Cul-de-sacs.

Cul-de-sacs shall not exceed a length of eight hundred (800) feet and shall be provided with a turnaround having a minimum radius of thirty-two (32) feet.

(Ord. No. 125, 6-2-87)

- Blocks.

Blocks shall have sufficient width for an ultimate layout of two (2) tiers of lots of a size required by the provisions of the zoning ordinance.

(Ord. No. 125, 6-2-87)

- Easements.

Easements shall be provided as necessary with the following minimum widths, as required by the city engineer:

Type	Minimum Width in Feet
Access easement	20
Utility easement	15

(Ord. No. 125, 6-2-87)