Yuba County · Zoning · TP
Yuba County TP zoning: height, setbacks and lot size
In Yuba County's TP zone, generally buildings can be up to 50 ft tall, the front setback is 30 ft and the minimum lot size is 160 acres, with the conditions listed below (Yuba County code, read October 2026).
Key points
- Maximum building height: 50 ft
- Minimum front setback: 30 ft
- Minimum side setback: 25 ft or 10% of lot width, whichever is less, but not less than 5 ft (Lots less than 1 acre)
- Minimum rear setback: 25 ft (Subject to footnote (A))
- Minimum lot size: 160 acres (Subject to footnote (B))
TP is a zoning district in Yuba County. Every value below was read from the Yuba County Municipal Code and links to its section (read October 2026). State laws such as the ADU and SB 9 rules can allow more on a residential lot. General information, not legal advice — read the code text and check with the city before you build.
Development standards in TP
The general rule for a typical lot in this zone. Zoning tables often attach notes, such as rules for corner lots, lots next to a residential zone, or new subdivisions only. Open “code text” under a value to see the table cell or sentence it was read from.
| Maximum building height | 50 ft § 11.11.030 · code textTable row “Maximum height (ft.)”, column “TP”: 50 |
|---|---|
| Minimum front setback | 30 ft § 11.11.030 · code textTable row “Front”, column “TP”: 30 |
| Minimum side setback | 25 ft or 10% of lot width, whichever is less, but not less than 5 ft Applies: Lots less than 1 acre § 11.11.030 · code textTable row “Side”, column “TP”: Lots less than 1 acre: 25 or 10 percent of lot width, whichever is less, but not less than 5 (A) Lots 1 acre or larger: 30 |
| Minimum rear setback | 25 ft Applies: Subject to footnote (A) § 11.11.030 · code textTable row “Rear”, column “TP”: 25(A) |
| Minimum lot size | 160 acres Applies: Subject to footnote (B) § 11.11.030 · code textTable row “Minimum Lot Area (acres)”, column “TP”: 160(B) |
Uses in TP
Uses the code's use tables allow in TP, or allow with a permit. Each links to its page with the code section.
- Single-family home — Allowed
When a different number applies
The code sets other values for particular lots, buildings or locations in TP:
- Minimum side setback: 30 ft — Lots 1 acre or larger § 11.11.030
Not on this page
We did not find a general stories, lot coverage, FAR, density limit for TP in the zoning tables we read. The code may still set one elsewhere — check the Yuba County Municipal Code.
Other Yuba County zoning districts
Who this affects
Frequently asked questions
What is the maximum building height in Yuba County's TP zone?
50 ft — Yuba County Municipal Code § 11.11.030.
What is the minimum front setback in Yuba County's TP zone?
30 ft — Yuba County Municipal Code § 11.11.030.
What is the minimum side setback in Yuba County's TP zone?
25 ft or 10% of lot width, whichever is less, but not less than 5 ft (lots less than 1 acre) — Yuba County Municipal Code § 11.11.030.
What is the minimum rear setback in Yuba County's TP zone?
25 ft (subject to footnote (A)) — Yuba County Municipal Code § 11.11.030.
What is the minimum lot size in Yuba County's TP zone?
160 acres (subject to footnote (B)) — Yuba County Municipal Code § 11.11.030.
General information, not legal advice.
Ask about a Yuba County property in TP
Ask GoCodebook what you can build at a specific address and get an answer that cites the section.
Ask your question