Skip to content

San Jose · Zoning · PQP

San Jose PQP zoning: height, setbacks and lot size

In San Jose's PQP zone, generally buildings can be up to 65 ft tall, the front setback is 10 ft and the minimum lot size is 6,000 sq ft, with the conditions listed below (San Jose code, read October 2026).

Key points

  • Maximum building height: 65 ft (unless a different maximum is set under Chapter 20.85, which then governs)
  • Minimum front setback: 10 ft (less than 10 ft if an approved development permit sets it)
  • Minimum side setback: 10 ft (less than 10 ft if an approved development permit sets it)
  • Minimum rear setback: 10 ft (less than 10 ft if an approved development permit sets it)
  • Minimum lot size: 6,000 sq ft

PQP is a zoning district in San Jose. Every value below was read from the San Jose Municipal Code and links to its section (read October 2026). State laws such as the ADU and SB 9 rules can allow more on a residential lot. General information, not legal advice — read the code text and check with the city before you build.

Development standards in PQP

The general rule for a typical lot in this zone. Zoning tables often attach notes, such as rules for corner lots, lots next to a residential zone, or new subdivisions only. Open “code text” under a value to see the table cell or sentence it was read from.

Maximum building height
65 ft
Applies: unless a different maximum is set under Chapter 20.85, which then governs
§ 20.40.200 · code text
Table row “Maximum height (feet) (Note 1 and 3)”, column “PQP”: 65, unless a different maximum is established in Chapter 20.85
Minimum front setback
10 ft
Applies: less than 10 ft if an approved development permit sets it
§ 20.40.200 · code text
Table row “Front”, column “PQP”: 10; less than 10 if established in approved development permit
Minimum side setback
10 ft
Applies: less than 10 ft if an approved development permit sets it
§ 20.40.200 · code text
Table row “Side, interior”, column “PQP”: 10; less than 10 if established in approved development permit
Minimum rear setback
10 ft
Applies: less than 10 ft if an approved development permit sets it
§ 20.40.200 · code text
Table row “Rear, interior”, column “PQP”: 10; less than 10 if established in approved development permit
Minimum lot size
6,000 sq ft
§ 20.40.200 · code text
Table row “Minimum lot area (square feet or acreage)”, column “PQP”: 6,000

Uses in PQP

Uses the code's use tables allow in PQP, or allow with a permit. Each links to its page with the code section.

Not on this page

We did not find a general stories, lot coverage, FAR, density limit for PQP in the zoning tables we read. The code may still set one elsewhere — check the San Jose Municipal Code.

Other San Jose zoning districts

Who this affects

HomeownersArchitects and designersDevelopersReal estate agents

Frequently asked questions

What is the maximum building height in San Jose's PQP zone?

65 ft (unless a different maximum is set under Chapter 20.85, which then governs) — San Jose Municipal Code § 20.40.200.

What is the minimum front setback in San Jose's PQP zone?

10 ft (less than 10 ft if an approved development permit sets it) — San Jose Municipal Code § 20.40.200.

What is the minimum side setback in San Jose's PQP zone?

10 ft (less than 10 ft if an approved development permit sets it) — San Jose Municipal Code § 20.40.200.

What is the minimum rear setback in San Jose's PQP zone?

10 ft (less than 10 ft if an approved development permit sets it) — San Jose Municipal Code § 20.40.200.

What is the minimum lot size in San Jose's PQP zone?

6,000 sq ft — San Jose Municipal Code § 20.40.200.

General information, not legal advice.

Ask about a San Jose property in PQP

Ask GoCodebook what you can build at a specific address and get an answer that cites the section.

Ask your question

More on San Jose