Plumas County · Zoning · C-1
Plumas County C-1 zoning: height, setbacks and lot size
In Plumas County's C-1 zone, buildings can be up to 35 ft tall and the front setback is None required (Plumas County code, read October 2026).
Key points
- Maximum building height: 35 ft
- Minimum front setback: None required
- Minimum side setback: None required
- Minimum rear setback: None required
C-1 (Core Commercial Zone) is a zoning district in Plumas County. Every value below was read from the Plumas County Municipal Code and links to its section (read October 2026). State laws such as the ADU and SB 9 rules can allow more on a residential lot. General information, not legal advice — read the code text and check with the city before you build.
Development standards in C-1
The general rule for a typical lot in this zone. Zoning tables often attach notes, such as rules for corner lots, lots next to a residential zone, or new subdivisions only. Open “code text” under a value to see the table cell or sentence it was read from.
| Maximum building height | 35 ft § 9-2.1903 · code textNo structure in the Core Commercial Zone (C-1) shall exceed thirty-five (35') feet in height. |
|---|---|
| Minimum front setback | None required § 9-2.1905 · code text(a) Front yards: None; and |
| Minimum side setback | None required § 9-2.1905 · code text(b) Side and rear yards: None, except ten (10') feet for yards adjacent to a residentially zoned parcel. |
| Minimum rear setback | None required § 9-2.1905 · code text(b) Side and rear yards: None, except ten (10') feet for yards adjacent to a residentially zoned parcel. |
When a different number applies
The code sets other values for particular lots, buildings or locations in C-1:
- Minimum side setback: 10 ft — yard adjacent to a residentially zoned parcel § 9-2.1905
- Minimum rear setback: 10 ft — yard adjacent to a residentially zoned parcel § 9-2.1905
Not on this page
We did not find a general stories, lot size, lot coverage, FAR, density limit for C-1 in the zoning tables we read. The code may still set one elsewhere — check the Plumas County Municipal Code.
Other Plumas County zoning districts
Who this affects
Frequently asked questions
What is the maximum building height in Plumas County's C-1 zone?
35 ft — Plumas County Municipal Code § 9-2.1903.
What is the minimum front setback in Plumas County's C-1 zone?
None required — Plumas County Municipal Code § 9-2.1905.
What is the minimum side setback in Plumas County's C-1 zone?
None required — Plumas County Municipal Code § 9-2.1905.
What is the minimum rear setback in Plumas County's C-1 zone?
None required — Plumas County Municipal Code § 9-2.1905.
General information, not legal advice.
Ask about a Plumas County property in C-1
Ask GoCodebook what you can build at a specific address and get an answer that cites the section.
Ask your question