Skip to content

Pinole · Zoning · R-1

Pinole R-1 zoning: height, setbacks and lot size

In Pinole's R-1 zone, buildings can be up to 35 ft tall and the front setback is 20 ft (Pinole code, read October 2026).

Key points

  • Maximum building height: 35 ft
  • Minimum front setback: 20 ft
  • Minimum side setback: 5 ft
  • Maximum density: 10.0 units per acre

R-1 (Suburban Residential Zoning District) is a zoning district in Pinole. Every value below was read from the Pinole Municipal Code and links to its section (read October 2026). State laws such as the ADU and SB 9 rules can allow more on a residential lot. General information, not legal advice — read the code text and check with the city before you build.

Development standards in R-1

The general rule for a typical lot in this zone. Zoning tables often attach notes, such as rules for corner lots, lots next to a residential zone, or new subdivisions only. Open “code text” under a value to see the table cell or sentence it was read from.

Maximum building height
35 ft
§ 17.24.020 · code text
Table row “Primary Buildings”, column “R-1”: 35
Minimum front setback
20 ft
§ 17.24.020 · code text
Table row “Front Yard”, column “R-1”: 20
Minimum side setback
5 ft
See note 3 below the table in the code.
§ 17.24.020 · code text
Table row “Side Yard”, column “R-1”: 5 (3)
Note 3: Within required side yards, at least one (1) side shall provide four (4) feet of unobstructed surface to allow unobstructed access between the front and rear yards.
Maximum density
10.0 units per acre
§ 17.24.020 · code text
Table row “Maximum Density”, column “R-1”: 10.0

Uses in R-1

Uses the code's use tables allow in R-1, or allow with a permit. Each links to its page with the code section.

When a different number applies

The code sets other values for particular lots, buildings or locations in R-1:

  • Minimum side setback: 12 ft — For a second story § 17.24.020

Not on this page

We did not find a general stories, rear setback, lot size, lot coverage, FAR limit for R-1 in the zoning tables we read. The code may still set one elsewhere — check the Pinole Municipal Code.

Other Pinole zoning districts

Who this affects

HomeownersArchitects and designersDevelopersReal estate agents

Frequently asked questions

What is the maximum building height in Pinole's R-1 zone?

35 ft — Pinole Municipal Code § 17.24.020.

What is the minimum front setback in Pinole's R-1 zone?

20 ft — Pinole Municipal Code § 17.24.020.

What is the minimum side setback in Pinole's R-1 zone?

5 ft — Pinole Municipal Code § 17.24.020.

What is the maximum density in Pinole's R-1 zone?

10.0 units per acre — Pinole Municipal Code § 17.24.020.

General information, not legal advice.

Ask about a Pinole property in R-1

Ask GoCodebook what you can build at a specific address and get an answer that cites the section.

Ask your question

More on Pinole