Farmersville · Zoning · C-G
Farmersville C-G zoning: height, setbacks and lot size
In Farmersville's C-G zone, buildings can be up to 40 ft tall, the front setback is 4 ft and the minimum lot size is 6,000 sq ft (Farmersville code, read October 2026).
Key points
- Maximum building height: 40 ft
- Minimum front setback: 4 ft
- Minimum side setback: None required (Interior side; the residential zone's rule applies where the lot abuts one)
- Minimum rear setback: None required
- Minimum lot size: 6,000 sq ft
C-G (General Commercial Zone) is a zoning district in Farmersville. Every value below was read from the Farmersville Municipal Code and links to its section (read October 2026). State laws such as the ADU and SB 9 rules can allow more on a residential lot. General information, not legal advice — read the code text and check with the city before you build.
Development standards in C-G
The general rule for a typical lot in this zone. Zoning tables often attach notes, such as rules for corner lots, lots next to a residential zone, or new subdivisions only. Open “code text” under a value to see the table cell or sentence it was read from.
| Maximum building height | 40 ft § 17.44.030 · code textNo principal building shall exceed forty feet in height except as provided in Chapter 17.88. |
|---|---|
| Minimum front setback | 4 ft § 17.44.040 · code textA. Front Yard: Buildings may be located no closer than four feet to the front property line. |
| Minimum side setback | None required Applies: Interior side; the residential zone's rule applies where the lot abuts one § 17.44.040 · code textSide Yards: Interior side, none; except when abutting a residential zone, then not less than required for said residential zone. |
| Minimum rear setback | None required § 17.44.040 · code textC. Rear Yard: None. |
| Minimum lot size | 6,000 sq ft § 17.44.040 · code textc. Minimum lot area: Six thousand square feet. |
When a different number applies
The code sets other values for particular lots, buildings or locations in C-G:
- Minimum front setback: 0 ft — May be reduced to zero feet if, in the opinion of the zoning administrator, the conditions of Chapter 17.96 are met. § 17.44.040
- Minimum side setback: Required for the abutting residential zone — When abutting a residential zone. § 17.44.040
Not on this page
We did not find a general stories, lot coverage, FAR, density limit for C-G in the zoning tables we read. The code may still set one elsewhere — check the Farmersville Municipal Code.
Other Farmersville zoning districts
Who this affects
Frequently asked questions
What is the maximum building height in Farmersville's C-G zone?
40 ft — Farmersville Municipal Code § 17.44.030.
What is the minimum front setback in Farmersville's C-G zone?
4 ft — Farmersville Municipal Code § 17.44.040.
What is the minimum side setback in Farmersville's C-G zone?
None required (interior side; the residential zone's rule applies where the lot abuts one) — Farmersville Municipal Code § 17.44.040.
What is the minimum rear setback in Farmersville's C-G zone?
None required — Farmersville Municipal Code § 17.44.040.
What is the minimum lot size in Farmersville's C-G zone?
6,000 sq ft — Farmersville Municipal Code § 17.44.040.
General information, not legal advice.
Ask about a Farmersville property in C-G
Ask GoCodebook what you can build at a specific address and get an answer that cites the section.
Ask your question