Skip to content

Albany · Zoning · SC

Albany SC zoning: height, setbacks and lot size

In Albany's SC zone, generally buildings can be up to 35 ft tall, the front setback is None required and the minimum lot size is None, with the conditions listed below (Albany code, read October 2026).

Key points

  • Maximum building height: 35 ft
  • Minimum front setback: None required (Along San Pablo Avenue only; any setback provided may be no deeper than four feet at street level)
  • Minimum lot size: None
  • Maximum lot coverage: 100%
  • Maximum floor area ratio (FAR): 1.25 (Mixed-use development)

SC is a zoning district in Albany. Every value below was read from the Albany Municipal Code and links to its section (read October 2026). State laws such as the ADU and SB 9 rules can allow more on a residential lot. General information, not legal advice — read the code text and check with the city before you build.

Development standards in SC

The general rule for a typical lot in this zone. Zoning tables often attach notes, such as rules for corner lots, lots next to a residential zone, or new subdivisions only. Open “code text” under a value to see the table cell or sentence it was read from.

Maximum building height
35 ft
§ 20.24 · code text
Table row “Maximum Building Height (feet)”, column “SC”: 35
Minimum front setback
None required
Applies: Along San Pablo Avenue only; any setback provided may be no deeper than four feet at street level
§ 20.24 · code text
None required along San Pablo Avenue.
Minimum lot size
None
§ 20.24 · code text
Table row “Minimum Lot Size (square feet)”, column “SC”: None
Maximum lot coverage
100%
§ 20.24 · code text
Table row “Maximum Lot Coverage (% of lot area)”, column “SC”: 100%
Maximum floor area ratio (FAR)
1.25
Applies: Mixed-use development
§ 20.24 · code text
Table row “Mixed-use development (more than 1 use, including residential and commercial or other permitted nonresidential uses)”, column “SC”: 1.25

Uses in SC

Uses the code's use tables allow in SC, or allow with a permit. Each links to its page with the code section.

When a different number applies

The code sets other values for particular lots, buildings or locations in SC:

  • Minimum front setback: 15 ft — Where fronting a street immediately parallel to San Pablo Avenue § 20.24
  • Minimum front setback: 15 ft — Exterior lot line on a street meeting Solano Avenue, with a residential district directly across that street § 20.24

Not on this page

We did not find a general stories, side setback, rear setback, density limit for SC in the zoning tables we read. The code may still set one elsewhere — check the Albany Municipal Code.

Other Albany zoning districts

Who this affects

HomeownersArchitects and designersDevelopersReal estate agents

Frequently asked questions

What is the maximum building height in Albany's SC zone?

35 ft — Albany Municipal Code § 20.24.

What is the minimum front setback in Albany's SC zone?

None required (along San Pablo Avenue only; any setback provided may be no deeper than four feet at street level) — Albany Municipal Code § 20.24.

What is the minimum lot size in Albany's SC zone?

None — Albany Municipal Code § 20.24.

What is the maximum lot coverage in Albany's SC zone?

100% — Albany Municipal Code § 20.24.

What is the maximum floor area ratio (far) in Albany's SC zone?

1.25 (mixed-use development) — Albany Municipal Code § 20.24.

General information, not legal advice.

Ask about an Albany property in SC

Ask GoCodebook what you can build at a specific address and get an answer that cites the section.

Ask your question

More on Albany